Moog DS2100 - Manual (Page 60)

DS2100 User's Manual (Preliminary)
SECTION 3: WIRING AND INSTALLATION
PAGE 3-54
3.11.5 Motor Encoder Connection
The DS2100 encoder input supports a variety of encoders. These include Analogue, SSI, Hiperface and Endat. The
connections to the drive for each of these encoder types are given in Table 3.25.
Encoder
Connector
Figure 3.38 Motor Encoder Connector Location
- Fixed connector: 15 pin, female Sub-D connector
- Mating connector, 15pin male Sub-D
- Wiring: cable. 28-18AWG (0.14-0.82mm 2 )
Encoder Type
Pos Analogue SSI Hiperface Endat
J4.1 Shield Shield Shield Shield
J4.2 - Sine - - Sine - Channel A
J4.3 - Cosine - - Cosine - Channel B
J4.4 Gnd Supply Gnd Supply Gnd Supply Gnd Supply
J4.5 - Channel Z (Zero) - Data RS485 - - Data
J4.6 - - Clock - - Clock
J4.7 - - - -
J4.8 NTC/PTC NTC/PTC NTC/PTC NTC/PTC
J4.9 + Sine - + Sine + Channel A
J4.10 + Cosine - + Cosine + Channel B
J4.11 +5 V .. +12V
Supply (150 mA
max.)
+5 V .. +12V
Supply (150 mA
max.)
+5 V .. +12V
Supply (150 mA
max.)
+5 V .. +12V
Supply (150 mA
max.)
J4.12 + Channel Z (Zero) + Data RS485 + + Data
J4.13 - Fault + Clock - + Clock
J4.14 Gnd Supply Gnd Supply Gnd Supply Gnd Supply
J4.15 NTC/PTC NTC/PTC NTC/PTC NTC/PTC
Table 3.25 Encoder Cable Input Connections