Moog DS2100 - Manual (Page 64)

DS2100 User's Manual (Preliminary)
SECTION 3: WIRING AND INSTALLATION
PAGE 3-58
3.12.1 General Purpose Description of the Digital Inputs
The DS2100 provides 8 digital inputs on connector J2A.
- Fixed connector: 9 pins, male connector
- Mating connector, 9 pins spring cage, female, supplied with the drive. Phoenix Contact (Part # FK-MC 0.5/9-ST-
2.5)
- Wiring: cable. 28-20AWG (0.14-0.5mm 2 )
- Wire stripping: 8 mm
Pos. Name Function
J2A.1 I1 Digital Input # 1 Drive Enable
J2A.2 I2 Digital Input # 2 User Configurable
J2A.3 I3 Digital Input # 3 User Configurable
J2A.4 I4 Digital Input # 4 User Configurable
J2A.5 I5 Digital Input # 5 User Configurable
J2A.6 I6 Digital Input # 6 User Configurable
J2A.7 I7 Digital Input # 7 User Configurable
J2A.8 I8 Digital Input # 8 User Configurable
J2A.9 RET Digital Input Ground
Table 3.26 J2A, DS2100 Digital Input connector
The following electrical description applies to all the digital inputs of the DS2100.
+5V
4K7 Digital Input I1-I8
SIGNAL
Optocoupler RET
3V3
Figure 3.41 DS2100 Generic Digital Inputs