Maytag MAH9700AW* - Manual (Page 19)

Troubleshooting Procedures
! WARNING
To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing, unless testing
requires power.
©2005 Maytag Services 16025909 Rev. 0 19
Diag.
Code
Description Trigger Action to be
taken
8
Water level
sensor fault.
Input signal
from water
level Sensor
is out of
range,
Washer will
beep and
pause the
wash cycle.
Displays "LE"
Go to “No water fill
Troubleshooting”.
9 Not Used
10
Unbalance
detected
during final
spin, which
prevented
the spinner
from
exceeding
400 rpm
Never
exceeded
400rpm due
to an
unbalance
load.
LED – Will display
“dc”
Go to "Wet Clothes
"Troubleshooting
Section"
E
Water
sensor level
fault.
Water level in
the machine
is believed to
be above the
overflow level.
When this
condition is
detected, the
machine will
automatically
begin
pumping
water out of
the machine
until it falls
below the
overflow level.
First check to see
that water valve is
not stuck. If water
valve is OK, check
water level sensor
11
Will not
remember
machine
settings
Difficulty in
reading
memory
Go to "Clear
diagnostic codes"
Disconnect and
reconnect the
washer power cord
at power supply
outlet.
If condition still
exists, replace
machine control
board.
12-14 Not Used
Diag.
Code
Description Trigger Action to be
taken
15 Stuck Key
A key is
sensed to be
pressed more
than 30
seconds, the
key will be
assumed to
be stuck
Display "E2". Go to
"Membrane Pad
Check" Check
connection of
keypad to control
board. Replace
LED Board if
necessary.
17
Door switch
was not
seen open
since the last
three final
spins
The door has
not been
opened after
two complete
wash cycles.
Door switch
was not seen
open since
the last two
final spins
Will display "od" If
door open sensing,
will cleared.
18
Detected
door lock
switch open
during cycle
when not
expected.
Open door
lock switch
with motor
running.
Check for loose
wire connections
Clear the diagnostic
code and recheck;
if reoccurs, perform
Diagnostic
Motor/Machine
Control Board test
Check for faulty
motor relay on the
machine control
board.
19-21 Not Used
22
Door switch
detected
open during
cycle (when
not paused).
Door switch is
detected open
and the door
locked switch
is read as
locked.
Go to "Door Lock
Test"
Troubleshooting
Section
23-24 Not Used