Maytag MAH9700AW* - Manual (Page 34)

34 16025909 Rev. 0 ©2005 Maytag Services
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.
Disassembly Procedures
WARNING
!
NOTE: When reinstalling Motor torqe nut to 32-47 ft. lbs.
6. Grasp the Rotor at 3 and 9 o’clock while pulling Rotor
from shaft.
CAUTION: The rotor contains powerful magnets. Use
caution during handeling and installation. DO
NOT place fingers between rotor and
windings during installation.
7. Depress and release latch to remove motor wiring
connectors.
8. Remove the six 10mm bolts securing stator coil to the
tub.
NOTE: There are alignment pins for the Stator
reinstallation. Use caution during removal and
installtion, the stastor will not hang from the
alignment pins. Start a screw while supporting
the Stator with the other hand.
5. Remove 19mm nut . 7. Depress and release latch to remove motor wiring
connectors.