IBM 6C4 - Manual (Page 54)

v OS Surveillance Setup Menu
This menu can be used to set up operating system (OS) surveillance.
OS Surveillance Setup Menu
1. Surveillance:
Currently Enabled
2. Surveillance Time Interval:
2 minutes
3. Surveillance Delay:
2 minutes
98. Return to Previous Menu
0>
– Surveillance
Can be set to Enabled or Disabled.
– Surveillance Time Interval
Can be set to any number from 2 through 255.
– Surveillance Delay
Can be set to any number from 0 through 255.
Refer to “Service Processor System Monitoring - Surveillance” on page 65 for more
information about surveillance.
v Reset Service Processor
If this option is selected, entering Y causes the service processor to reboot.
v Reprogram Flash EPROM Menu
This option requires a diskette drive to be installed in the system. If this option is
selected, and no diskette drive is present in the system, the service processor will
indicate
″
Not Supported
″
on the screen.
This option updates the system EPROMs. After entering Y to indicate that you want
to continue, you are prompted to enter the update diskettes. Follow the instructions
on the screen. When the update is complete, the service processor reboots.
All system EPROMs that can be reprogrammed are updated at the same time and
are as follows:
– System power control network programming
– Service processor programming
– System firmware programming
– Run-Time Abstraction Services
36 pSeries 630 Model 6C4 and Model 6E4 User’s Guide