IBM 6C4 - Manual (Page 62)

v Boot Mode Menu
The Boot Mode Menu allows you to select a boot mode.
Boot Mode Menu
1. Boot to SMS Menu:
Currently Disabled
2. Service Mode Boot from Saved List:
Currently Disabled
3. Service Mode Boot from Default List:
Currently Disabled
4. Boot to Open Firmware Prompt:
Currently Disabled
98. Return to Previous Menu
0>
To select a boot mode, select a number and press Enter. The item corresponding to
the selected number toggles between Disabled to Enabled. If a boot mode is
Enabled, the boot mode selected is performed, and the Disabled/Enabled selection is
reset to Disabled. The following describes each boot mode:
– Boot to SMS Menu
When this selection is enabled, the system boots to the System Management
Services (SMS) Menu.
– Service Mode Boot from Saved List
This selection causes the system to perform a service mode boot using the
service mode boot list saved in NVRAM. If the system boots AIX from the disk
drive and AIX diagnostics are loaded on the disk drive, AIX boots to the
diagnostics menu.
Using this option to boot the system is the preferred way to run online diagnostics.
– Service Mode Boot from Default List
This selection is similar to Service Mode Boot from Saved List , except the system
boots using the default boot list that is stored in the system firmware. This is
normally used to try to boot customer diagnostics from the CD-ROM drive.
Using this option to boot the system is the preferred way to run standalone
diagnostics.
– Boot to Open Firmware
This option should only be used by service personnel to obtain additional debug
information. When this selection is enabled, the system boots to the open
firmware prompt.
44 pSeries 630 Model 6C4 and Model 6E4 User’s Guide