IBM SC30-3865-04 - Manual (Page 120)

Table 6. Configuration Parameter List - HPR Timer and Retry Options (continued)
Parameter Information
Parameter
RTP inactivity timer
Valid Values
1 to 3600 seconds
Default Value
180 seconds
Description
This parameter specifies RTP’s inactivity interval for HPR connections that carry traffic
with
low transmission priority. This is an end-to-end version of the LLC inactivity timer,
Ti. If no receptions occur during this interval, RTP transmits a poll. Idle periods are
monitored to ensure the integrity of the connection.
Parameter
Maximum RTP retries
Valid Values
0 to 10
Default Value
6
Description
This parameter specifies the maximum number of retries before RTP initiates a path
switch on an HPR connection that carries traffic with low transmission priority.
Parameter
Path switch timer
Valid Values
0 to 7200 seconds
Default Value
180 seconds
Description
This parameter specifies the maximum amount of time that a path switch may be
attempted on an HPR connection carrying traffic with low transmission priority. A value
of zero indicates that the path switch function is to be disabled, and a path switch will
not be performed.
Medium transmission priority traffic
Parameter
RTP inactivity timer
Valid Values
1 to 3600 seconds
Default Value
180 seconds
Description
This parameter specifies RTP’s inactivity interval for HPR connections that carry traffic
with
medium transmission priority. This is an end-to-end version of the LLC inactivity
timer, Ti. If no receptions occur during this interval, RTP transmits a poll. Idle periods
are monitored to ensure the integrity of the connection.
APPN Configuration Commands
90 MRS V3.2 Protocol Config Ref Vol 2