IBM SC30-3865-04 - Manual (Page 438)

Config> p ndp6
Neighbor Discovery for IPv6 user configuration
NDP6 Config> change prefix
Change Prefix Information option for which Prefix address []? 2002:2::
Use this prefix for on-link determination? [Yes]:
Use this prefix for autonomous address configuration? [Yes]: n
Valid lifetime for Prefix [2592000]? ffffffff
Preferred Lifetime for Prefix [604800]? ffffffff
Change prefix information options for which prefix address?
Specifies the IPv6 address prefix to be placed in the prefix
information option in router advertisements sent from the interface.
Valid Values: Any valid IPv6 address
Default Value: None
Use this prefix for on-link determination?
Specifies the value to be placed in the on-link flag in the prefix
information option. When set to
yes, the prefix can be used for
on-link determination. When set to no, the advertisement will make
no statement about on-link or off-link properties of the prefix.
Valid Values: yes or no
Default Value: yes
Use this prefix for autonomous address configuration?
Specifies the value to be placed in the autonomous address
configuration flag in the prefix information option. When set to
yes,
the prefix can be used for autonomous address configuration.
Valid Values: yes or no
Default Value: yes
valid lifetime for prefix
Specifies the amount of time, in seconds, to be placed in the valid
lifetime in the prefix information option. This value represents the
length of time, relative to the time that the packet is sent, that the
prefix is valid for the purpose of on-link determination.
Valid Values: A 32–bit unsigned integer, where X'FFFFFFFF'
represents unlimited lifetime
Default Value: 259200 (which is 30 days)
Preferred lifetime for prefix
Specifies the amount of time, in seconds, to be placed in the
preferred lifetime in the prefix information option. This value
represents the length of time, relative to the time that the packet is
sent, that addresses generated from the prefix via stateless address
autoconfiguration remain preferred.
Valid Values: A 32–bit unsigned integer, where X'FFFFFFFF'
represents unlimited lifetime
Default Value: 604800
Delete
Use the delete command to remove a configured route advertisement.
Syntax:
NDP Configuration Commands (Talk 6)
408 MRS V3.2 Protocol Config Ref Vol 2
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|