IBM SC30-3865-04 - Manual (Page 425)

Add
Use the update packet-filter add command to add an access control list.
Syntax:
add access-control type sourceaddr sourceprefix
destaddr destprefix
access-control
Adds an access-control item to the access control list.
Type Specifies whether the access control is inclusive or used to identify
packets to be secured.
Valid Values: I or S
Default Value: I
Internet source
Specifies the IPv6 address of the packet source.
Valid Values: Any valid IPv6 address
Default Value: None
Prefix length
Decimal value specifying how many of the leftmost contiguous bits
of the IPv6 address comprise the prefix.
Valid Values: 0- 128
Default Value: 128
Internet destination
Specifies the IPv6 address of the packet destination.
Valid Values: Any valid IPv6 address
Default Value: None
Prefix length
Decimal value specifying how many of the leftmost contiguous bits
of the IPv6 address comprise the prefix.
Valid Values: 0- 128
Default Value: 128
Change
Use the update packet-filter change command to change access control.
Syntax:
change access-control type sourceaddr sourceprefix
destaddr destprefix
access-control
Changes an access-control item.
Type Specifies whether the access control item is inclusive or used to
identify packets to be secured..
Valid Values: I or S
Default Value: I
IPV6 Configuration Commands (Talk 6)
Chapter 14. Configuring and Monitoring IPV6 395
|
|
|
||
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
||
|
|
|