IBM SC30-3865-04 - Manual (Page 214)

Table 33. Configuration Parameter List - APPN COS - Mode Name to COS Name Mapping
- Detail (continued)
Parameter Information
Parameter
COS name (required)
Valid Values
The name of a previously defined COS definition, selected from the list of COS names
defined for this router network node.
Default Value
None
Description
This parameter specifies the COS Name to be associated with the Mode name being
defined for this mode name to COS name mapping.
Parameter
Session-level pacing Command Line option size
Valid Values
1 to 63
Default Value
7
Description
This parameter specifies the session-level pacing Command Line option size. This
parameter has different definitions depending upon the type of pacing used:
v For fixed session-level pacing:
– The session-level pacing Command Line option size parameter specifies the
receive pacing Command Line option for this node.
– The value of this parameter is the suggested receive pacing Command Line
option for the adjacent node.
v For adaptive session-level pacing:
– The session-level pacing Command Line option size parameter specifies a tuning
parameter to be used as the minimum size for Isolated Pacing Messages sent by
the adjacent nodes.
Syntax:
add additional-port-to-connection-network
You will be prompted to enter values for the following parameters. The
parameter range will be shown in parentheses ( ). The parameter default
will be shown in square brackets [ ].
Note: You can have a maximum of 5 ports per connection network
definition.
APPN Configuration Commands
184 MRS V3.2 Protocol Config Ref Vol 2