IBM SC30-3865-04 - Manual (Page 93)

Outbound calls = allowed
Inbound calls = allowed
Idle timer = 0 (fixed circuit)
SelfTest Delay Timer = 150 ms
Circuit config: 3>ex
Config>net 2
V.34 Data Link Configuration
V.34 System Net Config 2>list all
V.34 System Net Configuration:
Local Network Address Name = default_address
Local Network Address = 9999999
Non-Responding addresses:
Retries = 1
Timeout = 0 seconds
Call timeouts:
Command Delay = 0 ms
Connect = 60 seconds
Disconnect = 2 seconds
Modem strings:
Initialization string = at&f&s1l1&d2&c1x3
Speed (bps) = 115200
V.34 System Net Config 2>set local
Local network address name []? gray
V.34 System Net Config 2>list all
V.34 System Net Configuration:
Local Network Address Name = gray
Local Network Address = 555-1212
Non-Responding addresses:
Retries = 1
Timeout = 0 seconds
Call timeouts:
Command Delay = 0 ms
Connect = 60 seconds
Disconnect = 2 seconds
Modem strings:
Initialization string = at&f&s1l1&d2&c1x3
Speed (bps) = 115200
V.34 System Net Config 2>
Notes:
1 A non-zero value for Idle Timer results in a dial-on-demand link
2 A zero value results in a leased link
Configuring APPN Over ATM
The following sample configures APPN over ATM.
Notes:
1. When PVCs are configured, the link station must be defined on both APPN
nodes wanting to use the PVC. The link station must be defined with Activate
link automatically= yes.
2. When parallel TGs over ATM are configured, the adjacent node name and TG
number must be defined in both nodes for each link station.
add po
APPN Port
Link Type: (P)PP, (FR)AME RELAY, (E)THERNET, (T)OKEN RING,
(S)DLC, (X)25, (D)LSw,(A)TM, (IP) [ ]?atm 1
APPN
Chapter 1. APPN 63