IBM SC30-3865-04 - Manual (Page 394)

Select ESI
Specify the ESI.
Use internally assigned selector
Use internally assigned selector or assign a selector in the range
00 to FF.
Use Best Effort Service for Data VCCs
Specifies the type of traffic characteristics to be associated with
Data VCCs. Bandwidth is not reserved for best effort traffic.
Peak Cell Rate of outbound Data VCCs (kbps)
Specifies the Peak Cell Rate (PCR) traffic parameter for the Data
VCCs.
Sustained Cell Rate of outbound Data VCCs (Kbps)
Specifies the Sustained Cell Rate (SCR) traffic parameter for the
Data VCCs.
Use ATM adapter’s burned-in MAC address for source?
You can use as the source MAC address for LANE shortcuts:
1. The adapter’s universally administered MAC address
2. The MAC address supplied in the NHRP resolution reply
3. The MAC address you configured by specifying a MAC address
using the change nhrp command.
See “ATM and LAN Emulation” in Software User’s Guide for further
information.
Note: It is recommended that you use the default values until you have
determined the specific processing options required by your
environment.
List
Use the list command to display the NHRP configuration information.
Syntax:
list all
exclude list
disallowed router-to-router shortcuts
interface definitions
cache size
all Displays the entire NHRP configuration.
Example: li all
Output is the same as for the list command. See “List” on page 360.
exclude list
Displays the exclude list entries.
Example: li exc
List of NHRP IP exclude records
-------------------------------
# Address Mask
1 7.7.7.7 255.255.255.255
NHRP Advanced Configuration Commands (Talk 6)
364 MRS V3.2 Protocol Config Ref Vol 2