IBM SC30-3865-04 - Manual (Page 400)

Syntax:
statistics all
interface
all Lists NHRP statistics on all interfaces.
Example: statistics all
Output is the same as that for the statistics interface command as shown
in the following example.
interface
Lists NHRP statistics on a specified interface.
Example:
statistics interface
Interface number [0]? 0
Statistics for Interface 0
--------------------------
Field Description Value
----------------- -----
Inbound Requests 5
Outbound Requests 3
Inbound Replies 3
Outbound Replies 5
Inbound Registers 0
Outbound Registers 0
Inbound Error Packets 0
Inbound Error Indication Packets 0
Outbound Error Indication Packets 0
Reply Forwards 0
Unrecognized Options 0
Registration Overflows 0
ProtocolErrors 0
Negative Outbound Replies 0
Inbound Packets on NHRP disabled interface 0
'Send_to_me' Outbound Replies 0
Inbound Purges 0
Outbound Purges 2
Cache
Use the cache command to display all NHRP resolution cache entries or a specific
cache entry identified by a destination address.
Syntax:
cache list
entry
list Lists NHRP cache entries.
entry Lists a specific NHRP cache entry.
Examples:
cache list
Total Client Cache Entries = 3
NHRP Client Cache Entries
=========================
Dest Address NextHop Address State Htime MTU Net
------------ --------------- ----- ----- --- ---
5.5.5.1 5.5.5.1 Act 1121 4490 1
5.5.5.2 5.5.5.2 Inact 1185 4490 1
6.6.6.1 6.6.6.1 Act 602 9180 0
NHRP Monitoring Commands (Talk 5)
370 MRS V3.2 Protocol Config Ref Vol 2