Integra DTR-9.1 - Manual (Page 22)

22
Assembling the AM loop antenna
Assemble the loop antenna as shown in the illustration.
• Refer to the next page for details on connecting the
AM loop antenna.
Connecting the AM antenna cable
1. Press down the lever.
2. Insert the wire into the hole.
3. Release the lever.
1 2 3
Insert into the hole.
AM
FM
75
ANTENNA
Connecting antennas
Connecting the included antennas
Connecting the FM indoor antenna:
The FM indoor antenna is for indoor use only. During
use, extend the antenna and move it in various direc-
tions until the clearest signal is received. Fix it with push
pins or similar implements in the position that will cause
the least amount of distortion.
If the reception is not very clear with the attached FM
indoor antenna, the use of an outdoor antenna is rec-
ommended.
Connecting the AM loop antenna:
The AM loop antenna is for indoor use only. Set it in the
direction and position where you receive the clearest
sound. Put it as far away as possible from the DTR-9.1,
televisions, speaker cables, and power cords.
When reception is not satisfactory with the attached
AM loop antenna alone, connection of an outdoor
antenna is recommended.
Strip away the insulation
from the end of the cable,
then fully insert the stripped
end of the cable.
FM antenna
(indoor)
AM loop antenna