Integra DTR-9.1 - Manual (Page 27)

27
Off On
Standby/On
Power Display DVD Video 1 Video 2 Video 3 Video 4 Video 5 Tape 1 Tape 2 AM FM Phono C D Open/Close
Zone 2 ( ) GRN Rec ( ) RED
Standby
Master Volume
DTR-9.1
OPEN/COLSE REC
AUDIO MUTING
DISC TRACK
DVD CD
PH TUN T2 T1
V1
STEREO
1 2 3
6 5 4
7
+ 10 0 ENT
8 9
SURROUND THX DSP
LEVEL + CH SEL Re-EQ
LEVEL – DIMMER
HOME THEATER CONTROLLER RC-418M
LATE NIGHT
DIRECT DSP
V2 V3 V –
SEND/LEARN
indicator
POWER ON
AUDIO MODE
Standby indicator
Standby/On
Power
POWER
STNBY
Connecting the power
Connecting the power
• The DTR-9.1 is shipped with the main power (POWER)
switch in the on position ( ON ). When the power
cord is plugged in for the first time, the DTR-9.1 will
automatically enter the standby state and the
STANDBY indicator will light (same condition after
step 2 below).
• Before you plug in the DTR-9.1, confirm that all con-
nections have been made properly.
• Turning on the power may cause a momentary
power surge, which might interfere with other elec-
trical equipment on the same circuit, such as com-
puters. If this happens, use a wall outlet on a differ-
ent circuit.
1. Plug the power cord into an AC wall outlet.
2. Press the POWER switch to set the DTR-9.1 to
standby state.
The STANDBY indicator will light up.
3. Press the STANDBY/ON button to turn on the
DTR-9.1. The display will light up and the
STANDBY indicator will turn off.
Display
DVD
VIDEO COMPONENT
ANALO G
1
INPUT
If you press the STANDBY/ON button again, the re-
ceiver returns to Standby mode.
Turning the power on from the remote controller:
Before you can use the remote controller, you must
perform steps 1 and 2 above and place the DTR-9.1 in
the standby state.
1. Press the AUDIO MODE button.
2. Press the POWER ON button to turn on the DTR-
9.1 (take it out of the standby state).
• To return the DTR-9.1 to the standby state, press
the POWER STNBY button.