Integra DTR-9.1 - Manual (Page 30)

30
1-1. Speaker Config sub-menu
Here you will enter which speakers are connected and
the size of each speaker.
Speaker Setup
1. Speaker Setup menu
After you have installed the DTR-9.1, connected all the
components, and determined the speaker layout, it is
now time to perform the settings in the Speaker Setup
menu for the optimum sound acoustics for your envi-
ronment and speaker layout.
Before you perform the following settings, it is important
that you first determine the following characteristics:
• The types and sizes of the speakers that are con-
nected.
• The distance from each speaker to your normal lis-
tening position.
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.Zone2 OSD Setup
6.About
Select: Exit:|EXIT|
Enter:|ENTER| Quit:|OSD|
1.Speaker Setup
1.Speaker Config
2.Speaker Distance
3.Level Calibration
4.Bass Peak Level
5.LFE Level Setup
Quit:|OSD|
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.Zone2 OSD Setup
6.About
Select: Exit:|EXIT|
Enter:|ENTER| Quit:|OSD|
1.Speaker Setup
1.Speaker Config
2.Speaker Distance
3.Level Calibration
4.Bass Peak Level
5.LFE Level
Quit:|OSD|
1-1.Speaker Config
a.Subwoofer :Yes
b.Front :Large
c.Center :Large
d.Surround L/R
:Large
e.Surround Back
:Large
Quit:|OSD|
Memo:
a. Subwoofer
Yes: Select when a subwoofer is connected.
No: Select when a subwoofer is not connected.
b. Front
Large: Select if the front speakers are large sized.
Small: Select if the front speakers are small sized.
• If “No” is selected for the Subwoofer setting, then
this setting is fixed to “Large.”
c. Center
None: Select if no center speaker is connected.
Large: Select if the center speaker is large sized.
Small: Select if the center speaker is small sized.
• If “Small” is selected for the Front setting, then
“Large” cannot be selected for this setting.
d. Surround L/R
None: Select if no surround left and right speakers are
connected.
Large: Select if the surround left and right speakers are
large sized.
Small: Select if the surround left and right speakers are
small sized.
• If “Small” is selected for the Front setting, then
“Large” cannot be selected for this setting.
e. Surround Back
None: Select if no surround back left and right speakers
are connected.
Large: Select if the surround back left and right speak-
ers are large sized.
Small: Select if the surround back left and right speak-
ers are small sized.
• If “None” is selected for the Surround L/R setting,
then this setting is fixed to “None.”
• If “Small” is selected for the Surround L/R setting,
then “Large” cannot be selected for this setting.
SL SR
SBL SBR
Front
[ ]m/ft
[ ]m/ft
[ ]
m/ft
[ ]m/ft
[ ]m/ft
[ ]m/ft [ ]m/ft
[ ]m/ft
Front
SW Center
Monitor
Tip:
When setting the speaker size in the Speaker Config
sub-menu, use the guidelines given below.
Large: The complete frequency range for the channel
you are setting will be output from the speaker.
Small: Frequencies of the channel you are setting lower
than 80 Hz will be output from the subwoofer.If the front
speakers are set to “Large,” then the sound may be
output from both the left and right speakers. (All THX
speakers are small.)