Integra DTR-9.1 - Manual (Page 24)

24
IR IN
MAIN ZONE 2
ZONE 2 OUT
BACK L
L
R
BACK R
R
L
SURROUND (SURR) SPEAKERS
AC OUTLETS
AC 120V 60Hz
SWITCHED
TOTAL 120W 1A MAX.
AC
INLET
AM ANT.
FM ANT.
75
MULTI
CHANNEL
INPUT
RS 232
GND
C
FRONT
AMP IN
R L
SURR BACK
SURR
PRE OUT
SUB WOOFER
FRONT
SPEAKERS
CENTER
SPEAKER
1
2
VIDEO S VIDEO
DVD
VIDEO
5
VIDEO 4
VIDEO 3
MONITOR OUT
VIDEO 1
VIDEO 2
OUT
IN
IN
IN
IN
IN
IN
OUT
R L VIDEO S VIDEO
C D
TAPE 2
TAPE 1 I N
I N
I N
I N
OUT
OUT
L R
PHONO
3
2
1
3
2
5
4
1
DIGITAL OUTPUT (COAXIAL)
AC-3
RF
DIGITAL INPUT (COAXIAL)
DIGITAL OUTPUT (OPTICAL)
DIGITAL INPUT (OPTICAL)
INPUT 2 PB PR Y INPUT 3 PB PR Y OUTPUT PB PR Y
COMPONENT VIDEO
INPUT 1 PB PR Y
1
2
R L
IR IN
MAIN ZONE 2
ZONE 2 OUT
R L
OUT
A
MODEL NO. DTR-9.1 AV RECEIVER
12 V TRIGGER
( 6 OHMS MIN. )
( 6 OHMS MIN. )
B
HOME THEATER CONTROLLER
RC-418M
Connecting to the IR IN ZONE 2 input
Main zone Remote zone (Zone 2)
Zone 2
speaker
Zone 2
speaker
Zone 2 monitor
or projector
Zone 2 amplifier
Remote sensor
(Multi-Room System kit) Remote controller Connecting block
(Multi-Room System kit)
DTR-9.1
Connection example for Onkyo’s Multi-room System kit
Audio connection cable
Video and S-video connection cables
Mini plug cable
Power supply
Wall outlet
Signal flow
Outline
The IR IN ZONE 2 input allows you to control the DTR-9.1
from the remote zone (Zone 2) with the remote control-
ler even though the remote zone is physically sepa-
rated. The diagram below shows how to make the
proper connections for the remote zone.
The following equipment (sold separately) is essential
for operation from the remote zone:
• Onkyo’s Multi-Room System kits (IR Remote Control-
ler Extension System), or
• Multiroom A/V distribution and control systems from
Niles ® and Xantech ® to name a few
Make connection as shown below. Do not plug the
equipment into the power source until the connection
is complete.
Connecting the main and remote zones
The ZONE 2 terminal is a constant output. Connect to
the LINE input of the amplifier (CD, tape, etc.). Adjust
the volume with the amplifier connected to the ZONE 2
terminal.
1. Connect the DTR-9.1 to the amplifier for the
remote zone.
2. Connect the remote zone speaker cables to
the speaker terminals on the amplifier.
3. Connect the DTR-9.1 to the monitor for the
remote zone.
4. Install the connecting block in the main zone
and connect it to the IR IN ZONE 2 input at the
DTR-9.1.
5. Install the remote sensor in the remote zone
and connect it to the connecting block in the
main zone.
LINE IN