Integra DTR-9.1 - Manual (Page 53)

53
Enjoying music or videos with the DTR-9.1
The operation is not allowed because headphones are
plugged into the DTR-9.1.
The operation is not allowed because the selected in-
put source is set for multichannel input.
The operation is not allowed by the current speaker
configuration.
No setting other than Dolby Digital can be set.
Using the sleep time:
To set the sleep timer, press the SLEEP button on the
remote controller and then set the time that you
want the DTR-9.1 to enter the standby state (see
page 57).
Temporarily turning off the sound:
To turn off the sound momentarily, such as when in-
terrupted by a phone call, press the MUTING button
on the remote controller (see page 57).
Adjusting the bass and treble:
You can adjust the bass and treble levels at the
Sound Effect sub-menu of the OSD menu: Input
Setup
→ Sound Effect (see page 40).
Adjusting the brightness of the front display:
You can adjust the brightness of the front display of
the DTR-9.1 with DIMMER button on the remote con-
troller or on the DTR-9.1 front panel (see page 57).
If one of the messages shown below appears
If one of the messages shown below appears in the
front display, it is telling you that the operation you are
trying to perform is not possible for the reason given in
the message.
Enjoying the multichannel output
Before you can use a component with multichannel
output, you must first select “Yes” for the Multichannel
setting in the OSD menu for that input source: Input
Setup
→ Multichannel Setup (see page 36).
1. Press the input source button for the
component with multichannel output
connected to the MULTI CHANNEL INPUT on
the rear of the DTR-9.1.
2. Turn on the connected component and start
playing the desired media.
3. If necessary, press the CH SEL button on the
remote controller to select an individual
speaker. Then press the LEVEL + or – button to
adjust the output level as desired.
Adjust the speaker output levels so that you can
hear the same sound level from each speaker at
the listening position. For the front right, front left,
center, surround right,surround left, surround back
right and surround back left speakers, the output
levels can be adjusted between –12 to +12 deci-
bels. The subwoofer can be adjusted between –30
and +10 decibels.
4. Adjust the volume with the MASTER VOLUME
dial or the VOL buttons on the remote
controller.