Erasing the programmed command from one button, Press and release the same button again, Press and release the same mode button again – Integra DTR-9.1 User Manual
Page 63: Mode buttons send/learn indicator ent
63
Programming the commands of remote controllers for other devices into
the remote controller
Erasing the programmed command from one
button
You can only erase memorized commands and not
preset ones.
1. Press and hold down the desired MODE button
for the command, press the ENT button, and
then release both buttons.
When you press the MODE button, the SEND/LEARN
indicator lights and that mode appears in the dis-
play. When you press the ENT button, the lamp turns
off. When you release the buttons, the lamp lights
again and “LEARN” appears in the display.
2. Press and release the button for the command
you wish to erase.
When you press the button, the SEND/LEARN indica-
tor turns off and “RCV” appears in the display. When
you release the button, the lamp lights again.
3. Press and release the same button again.
The SEND/LEARN lamp flashes twice slowly and
“CLEAR” appears in the display. The memorized
command is erased.
Note:
• If no button is pressed for more than 30 seconds dur-
ing the programming, the SEND/LEARN indicator
flashes three times quickly, “ERROR” appears in the
display, and the remote controller exits the pro-
gramming mode. Resume from Step 1.
Erasing all the commands programmed under
a MODE button
1. Press and hold down the desired MODE
button, press the ENT button twice, and then
release both buttons.
When you press the MODE button, the SEND/LEARN
indicator lights and that mode appears in the dis-
play. When you press the ENT button, the lamp turns
off. When you release the buttons, the lamp flashes
twice slowly and then lights again.
2. Press and release the same MODE button
again.
When you release the button, the SEND/LEARN indi-
cator flashes twice slowly. This erases all the com-
mands memorized to the MODE button.
Notes:
• If no button is pressed for more than 30 seconds dur-
ing the programming, the SEND/LEARN indicator
flashes three times quickly and the remote control-
ler exits the programming mode. Resume from Step
1.
• If you perform an invalid operation during program-
ming, the SEND/LEARN indicator flashes three times
quickly, “ERROR” appears in the display, and the re-
mote controller exits the programming mode. Re-
sume from Step 1.
• If many commands have been programmed to the
MODE button, then the SEND/LEARN indicator may
remain lit for some time during Step 2. This is not a
malfunction.
OPEN/COLSE
REC
AUDIO
MUTING
DISC
TRACK
DVD
CD
PH
TUN
T2
T1
V1
STEREO
1
2
3
6
5
4
7
+ 10
0
ENT
8
9
SURROUND
THX
DSP
LEVEL +
CH SEL
Re-EQ
LEVEL –
DIMMER
LATE NIGHT
DIRECT
DSP
V2
V3
V –
MODE
buttons
SEND/LEARN
indicator
ENT
HOME THEATER CONTROLLER
RC-418M
OPEN/COLSE
REC
AUDIO
MUTING
DISC
TRACK
DVD
CD
PH
TUN
T2
T1
V1
STEREO
1
2
3
6
5
4
7
+ 10
0
ENT
8
9
SURROUND
THX
DSP
LEVEL +
CH SEL
Re-EQ
LEVEL –
DIMMER
LATE NIGHT
DIRECT
DSP
V2
V3
V –
MODE
buttons
SEND/LEARN
indicator
ENT
HOME THEATER CONTROLLER
RC-418M