Iomega 9000 Series User Manual
Page 30
Upgrading Your Computer 23
•
You may need to run an installation program
provided by the board manufacturer before or after
installing or removing an add-in board. Refer to the
board documentation for more information.
2.
Turn the computer off, unplug the power cord,
disconnect all peripheral devices, and remove the system
cover (see “Replacing the System Cover” on page 21).
3.
Set all the necessary jumpers or switches on the add-in
board. See the add-in board documentation for details.
4.
Determine whether your add-in card is a PCI or ISA card,
then select an unused expansion slot (Figure 11). Be aware
that any cables that attach the add-in board to the system
board must be threaded around the riser card.
Figure 11. Riser Card Slot Locations
5.
Remove the bracket screw and the bracket for the selected
expansion slot.
6.
Install the add-in board:
a.
Line up the board with the expansion slot (Figure
12).
3694manl.bk : 3694manl.fm Page 23 Tuesday, December 24, 1996 9:15 AM