Iomega 9000 Series - Manual (Page 39)

32 Advantage! 9000 Series User’s Manual
Do not perform a low-level format on an AST IDE drive;
you might damage the format data. IDE drives sold by
AST have been low-level formatted at the factory.
You do not need to perform FDISK or FORMAT on the
hard drive that came with your computer. If you ever need
to repartition or reformat this hard drive, back up its data
first. Partitioning and formatting a hard drive deletes all
of the data on it
Installing a Drive in the Rear Drive Bay
Before installing a drive in the rear drive bay, you must first
remove the rear drive bay panel.
Removing the Rear Drive Bay Panel
To remove the rear drive bay panel from the back panel of the
system:
1. Remove the two screws on the left edge of the rear drive
bay panel (Figure 18).
Figure 18. Removing the Rear Drive Bay Panel
2. Lift the panel off the chassis.
3694manl.bk : 3694manl.fm Page 32 Tuesday, December 24, 1996 9:15 AM