Iomega 9000 Series - Manual (Page 45)

38 Advantage! 9000 Series User’s Manual
1. Turn the computer off, unplug the power cord, and
disconnect all peripheral devices.
2. Remove the system cover (see “Removing the System
Cover” on page 19).
3. Carefully lay the system over on its right side.
4. Remove any add-in boards (see “Installing Add-in
Boards” on page 21) that may block access to the
microprocessor socket.
5. Locate the microprocessor ZIF socket (see the illustration
in the back of this manual).
When you install the microprocessor, do not touch the
edges of the empty bracket for the 3.5-inch floppy drive.
The edges are sharp.
6. Insert the microprocessor into the socket (Figure 20):
a. Locate the lever on the side of the socket. Pull the
lever slightly away from the socket, then upward
until it is perpendicular to the system board.
Remove the existing microprocessor and store it in
an antistatic bag.
Figure 20. Installing the CPU
3694manl.bk : 3694manl.fm Page 38 Tuesday, December 24, 1996 9:15 AM