Iomega 9000 Series User Manual
Page 31
24 Advantage! 9000 Series User’s Manual
Figure 12. Installing an Add-in Board
b.
Insert the board until its edge connector is aligned
with an expansion-slot receptacle.
c.
Using evenly distributed pressure, push the board
straight in until it is fully inserted in the slot.
d.
Reinstall the bracket screw you removed in step 5.
7.
Attach any cables needed to connect the add-in board to
internal components. For more information, see the
manufacturer’s user’s manual. Note the following:
•
If the board requires a cable to be attached to a device
on the other side of the chassis, a slot on the riser card/
fan support provides a way to route cables without
interfering with the system cover.
•
If the board is a video-capture or other video board
that requires a pass-through VGA connection, connect
the pass-through cable to the VESA feature connector
(see the illustration in the back of this manual).
8.
Replace the bottom panel. Set the system upright and
replace the system cover. Reconnect peripheral devices,
plug in the power cord, and boot the system.
3694manl.bk : 3694manl.fm Page 24 Tuesday, December 24, 1996 9:15 AM