JAI AD-081GE - Manual (Page 10)

AD-081GE
9
5. Pin configuration
5.1. 12-pin Multi-connector (DC-in/GPIO/Iris Video)
Type: HR10A-10R-12PB
(Hirose) male.
(Seen from the rear of
camera)
Fig. 2. 12-pin connector.
5.2. Digital Output Connector for Gigabit Ethernet
Type: RJ-45 : HFJ11-1G02E-L21RL or equivalent
The digital output signals follow
the Gigabit Ethernet interface
using an RJ-45 conforming
connector. To the right is a table
with the pin assignment for
Gigabit Ethernet connector.
Fig. 3. Gigabit Ethernet
connector
5.3. 6-pin Multi-connector (LVDS IN and TTL IN/OUT)
Type : HR-10A-7R-6PB
注
Fig.4 HIROSE 6-pin connector *1:can be changed by DIP switches.
*2: Open collector or TTL level can be selected by an
internal DIP switch. Factory default is TTL.
Pin no. Signal Remarks
1 GND
2 +12 V DC input
3 Opt IN 2 (-) / GND (*1)
GPIO IN / OUT
4 Opt IN 2 (+)/Iris Video out (*1)
5 Opt IN 1 ( - )
6 Opt IN 1 ( + )
7 Opt Out 1 ( - )
8 Opt Out 1 ( + )
9 Opt Out 2 ( - )
10 Opt Out 2 ( + )
11 + 12 V DC input
12 GND
*1: Iris Video output function can be set by the internal DIP switch
(SW700).
Pin No In/Out Name
1 In/Out MX1+ (DA+)
2 In/Out MX1- (DA-)
3 In/Out MX2+ (DB+)
4 In/Out MX3+ (DC+)
5 In/Out MX3- (DC-)
6 In/Out MX2- (DB-)
7 In/Out MX4+ (DD+)
8 In/Out MX4- (DD-)
No I/O Name Note
1 I LVDS In 1-
2 I LVDS In 1+
3 I TTL IN 1 75ohm Terminator (Note*1)
4 O TTL Out 1 Note*2)
5 I TTL IN 2 75ohm Terminator(Note*1)
6 GND
3
4
5
6
7
8
9
10
11 12
1
2
1 2 3 4 5 6 7 8
1
2
3 4
5
6