Special note for settings, 1 when the image size is changed, 2 when the image is captured – JAI AD-081GE User Manual
Page 63: 3 acquisition frame rate, Ad-081ge
AD-081GE
62
10.7. Special note for settings
10.7.1 When the image size is changed
When the image size needs to be changed while the image is being captured, you must stop
image capturing by pressing “Stop Acquisition”. Then change the value. It is possible to set
the shutter value and gain settings while watching the picture on the screen.
10.7.2 When the image is captured
While capturing images, if the frame rate is decreased, please check packet size. Each
packet contains header information. If the packet size is small, total data bandwidth
is affected by all the headers that must be added to packets. Accordingly, the
frame rate may be decreased. If so, it is recommended to set the packet size to a higher value.
Please note that the packet size is not stored, and it is necessary to set it on every
start up. The current frame rate is shown at the bottom of the camera control tool.
(Note: the above figure is from BM/BB-141GE)
10.7.3 Acquisition frame rate
Acquisition frame rate is a function to set the frame rate of image capturing. The frame rate
can be set at full, 1/2, 1/4 and 1/8. This is only useful in “Continuous” mode. If a trigger mode
is used, it is strongly recommended to use the full frame rate. Otherwise, the trigger frequency
will also be divided according to the frame rate setting.
(Note: The above figure shows an example from a camera other than the AD-081GE.)