JAI AD-081GE - Manual (Page 60)

AD-081GE
59
10.5.9 Optical Black transfer mode
It is possible for the user to decide whether the optical black (OB) portion of the image will be
transferred or not. The optical black part can be used for black reference in the application
software. Setting register 0xA41C turns the optical black transfer ON or OFF. The default
condition is OFF.
OB Transfer Mode OFF OB Transfer Mode ON
Normal Scan
1 1024
1
768
1 1024 1040
1
16 pixels for
horizontal
are added.
1044
Fast Dump
(Partial Scan)
1 1024
1
1 1024 1040
1
16 pixels for
horizontal are
added
V Binning
1 1024
1
384
1 1024 1040
1
384
Note: The menu for ON or OFF of OB transfer mode is found on the Image Format Control of the
JAI SDK Camera Control Tool.
10.5.10 Multi ROI mode (Multi Region of Interest)
In this trigger mode, up to 5 ROIs located on one image can
be output by one trigger input. By using this mode, the
data stream can be smaller.
Each ROI can be overlapped.
Please note that if the accumulated data size is bigger than
the data size of 1 frame, the frame rate will be reduced.
Also note that these ROI settings are also used for partial
scanning. In the diagram shown to the right, the start line
of ROI2 and the end line of ROI4 would define the height for partial scan mode.
16 pixels for
horizontal
are added.
ROI
1
ROI 2
ROI
3
ROI 4
ROI 5