JAI AD-081GE - Manual (Page 51)

AD-081GE
50
10.5.2 Edge Pre-Select (EPS) trigger mode
An external trigger pulse initiates the capture, and the exposure time (accumulation time) is
the fixed shutter speed set by registers. The accumulation can be LVAL synchronous or LVAL
asynchronous. The resulting video signal will start to be read out after the selected shutter
time.
For timing details, refer to fig. 35 through fig. 44.
To use this mode:
Set function:
Trigger mode Edge Pre-select (EPS)
Readout mode Sync, async,
Output Select 8-bit, 10-bit, 12-bit
Scanning Full/Partial
Vertical binning ON/OFF
Shutter Programmable, Exposure Time Abs
Programmable Shutter 0.5 to 792 L (1L unit)
Accumulation(Auto) LVAL sync/LVAL async
Other functions
Input: External Trigger GigE I/F, Hirose 12-pin,Hirose 6-pin
Important Note:
1 The minimum duration of the trigger is 2L. The minimum period of trigger is as follows.
Sync mode:
Sync Smearless OFF FVAL(792L) + 3L + (Difference shutter time between
BW1 and BW2)
Smearless ON Smearless Time(198L)+1+ ( longer exposure time
between BW1 and BW2) + FVAL(792L) + 3L
Sync mode:
Async Smearless OFF FVAL(792L) + 3L
Smearless ON Smearless Time(198L)+1＋FVAL(792L)+3L
FVAL(792L) is the FVAL period of continuous operation.
2 In case that “Readout mode” is set to “SYNC”, the trigger input for BW1 is used for both
channels. The exposure time can be set individually, but the output timing is
synchronized with the rising edge of the longest exposure time.
Fig.41 Edge Pre-select LVAL asynchronous