JVC VR-N1600U - Manual (Page 103)

95
The input/output port is the input/output terminal that is found on
each device registered with this unit. You can register the input port
as [Input events], and the output port as [Outputs...].
A registered input/output port can be linked to an event as
described below. (
APage 102 [Specifying an Output Port])
● Events can be used to start recording, send e-mails, move the
PTZ camera to a preset position, and control the output port of
the device. Events are divided into the four types as described
below.
I/O Settings
1
Click the [I/O Setup...] button on the [Camera
Record Setting] screen
● The [I/O Setup] screen appears.
● The [I/O Setup] screen enables you to add input events,
VMD events and outputs that can be used by the network
cameras.
Note :
● The available events differ among network cameras.
● When an event is defined using the [I/O Setup] screen, this
automatically overwrites the alarm settings at the camera. If a
generic event is already in use (when the alarm settings at the
camera are configured manually), the generic event or the event
audio that makes use of the generic event (
A Page 128) will be
disabled. However, the generic event settings at the recorder
unit remain unchanged. (VR-N1600U/E)
Camera Input/Output Port
and Events
Input events Registers input signals of sensors connected
to the input port of the device as an [Input
events].
Generic events Registers as a generic event.
VMD events Registers the detected image motion as a
VMD (Video Motion Detection) event.
Event buttons Event generated by buttons that enable
manual operation.
A
B
C F
E
D
[I/O Setup] Screen
Item Description
A Add new
event... For specifying input events for the device
selected in the [Defined events] list. You
may be able to specify multiple input
events for some devices.
Click the [+] mark next to the device in the
[Defined events] list, select the preset
input event, and click the [Add new
event...] button to specify a timer event.
(
A Page 97)
B Add new
output event... Displays the [Add new output] screen.
(
A Page 98)
C Add VMD
Event(Motion
Detection) For specifying a VMD (Video Motion
Detection) event for the device selected in
the [Defined events] list. Only one VMD
event can be defined for each camera.
Note :
● To avoid the risk of generating an
excessive number of VMD events, a
new VMD event cannot occur within
five seconds after the occurrence of
the last VMD event.
● VMD events cannot be sent by e-mail.
D Advanced... Displays the [Advanced...] screen.
(
A Page 98)
E Remove
selected For deleting the event selected in the
[Defined events] list.
F Edit
selected... For editing the event selected in the
[Defined events] list.