JVC VR-N1600U - Manual (Page 115)

107
E mail Settings
Memo :
● You can send a test e-mail by clicking the [Test] button. If the e-
mail address of the sender is not registered with the mail server
of the recipient, the [The mail address of the sender is not valid.
...] message may appear. When this occurs, double-check the
sender’s e-mail address and outgoing mail server, and re-enter
the e-mail address.
● E-mail messages are sent in the following cases.
● When an input event occurs
( APage 96 [Specifying an Input Event])
● When the event button is clicked
( APage 99 [Configuring Event Buttons])
● When a generic event occurs
( APage 100 [Specifying Generic Events])
● When motion is detected
( APage 104 [Specifying Motion Detection.])
● When camera failure occurs
● When an archiving error occurs
( APage 108 [Archiving])
● In order to send an e-mail via Motion Detection, you need to
specify the timing for sending out e-mails in [Scheduler Setting]
(
A Page 53).
● After you have completed the e-mail setting, perform a test to
verify that it can be sent successfully.
A
B
C
D
E
G
F
[E-mal setup] Screen
Item Description
A Enable E-
mail(Monitor) Select this check box to enable sending of
e-mail alerts.
B Recipient(S) For specifying the e-mail addresses to
send alerts to. If you are specifying more
than one e-mail address, separate the e-
mail addresses using semicolons.
C Sender
Settings For specifying the sender’s e-mail address,
outgoing (SMTP) mail server name and
login settings.
D Subject text For specifying the mail title.
E Message text For specifying the message text.
F Time
btw.mail(min
utes) For specifying the time interval (minutes)
for sending each e-mail alert.
G Include
Image Select this check box to include images in
the message.