JVC VR-N1600U - Manual (Page 89)

81
Item Preset Values Description
Reference
Page
A IP Lease ⅷ Enable
Disable
For configuring the function to assign IP addresses to each network
camera.
Memo :
● In order to assign an IP address of the network camera using the
IP Lease feature, you need to enable the DHCP of the network
camera. For procedures to enable the DHCP of the network
camera, refer to the [INSTRUCRTIONS] of the network camera.
● If a network uses a multiple number of this product, enable [IP
Lease] only for one unit. Select ADisableB if a DHCP server is
operating on the same network. When the [IP Lease] is enabled for
two or more devices at the same time, the IP address may change
to a static address, and cause malfunction of the cameras.
A Page 113
B IP Lease Parameter ^
Start Address ⅷ 192.168.0.100 For specifying the first IP address to be assigned to the cameras.
Unit ⅷ 20Units
1Unit to 99Units
For selecting the number of IP addresses to be assigned to the
cameras. The selected number of IP addresses will be assigned
starting from the first IP address.
Subnet Mask ⅷ 255.255.255.0 For specifying the subnet mask for the cameras.
Gateway ⅷ 192.168.0.254 For specifying the gateway for the cameras.
DNS Server
Primary ⅷ 192.168.0.253 For specifying the primary DNS for the cameras.
Secondry ⅷ 192.168.0.252 For specifying the secondary DNS for the cameras.
Domain Name ^ For specifying the domain name for the cameras.
C Lease Time Limit ⅷ No
Yes
For specifying the valid period of the IP address assigned to the
cameras.
If
AYesB is selected, you can set the lease time in units of hours.
(Setting value: 1 hour to 99 hours)
^
D Client ⅷ Only Camera
Any Client
For selecting whether to apply restrictions on the device when
assigning the IP address. If
AOnly CameraB is selected, IP address
will only be assigned to the corresponding camera. If AAny ClientB is
selected, IP address will be assigned to all devices.
^