JVC VR-N1600U - Manual (Page 135)

127
4
Press the [Connect] button to connect to the
camera and start audio transmission
● Connection status with the camera is displayed in the
[Status] area of the [Status Information] list. Press the
[Connect] button and audio sound that input to [AUDIO IN
1] terminal of this unit will be transmitted to the cameras
that are displayed as
AConnectedB.
● If ADisconnectedB appears, check the network between
this unit and the camera, IP address of the camera, and
the power of the camera. If [Authentication failed] appears,
repeat procedures on the [Event Audio Setting] screen to
register the password of the camera for which the
[Authentication failed] message is displayed.
[Password] (
A Page 130)
5
Press the [Disconnect] button to disconnect the
camera
Memo :
● Cameras that are not registered in [Camera Record Setting] of
the main menu cannot be selected.
● If the audio setting of the camera is set to the half duplex mode,
you will not be able to hear audio sound from the camera when
in the
AConnectB status.
● If you are sending the microphone sound to a camera for which
an event audio has been set, the audio playback function that is
associated with an event will be disabled during microphone
sound transmission, and priority is given to the microphone
sound transmission.
● You can also operate the [Connect] and [Disconnect] button from
the alarm terminal on the rear panel. In this case, select the
alarm terminal to be used for control with [Push To Talk] under
[Event Audio Setting]. An alarm input triggers an action
equivalent to the [Connect] button, and canceling the alarm is
equivalent to the action when you pressed the [Disconnect]
button. Control of the [Connect] and [Disconnect] is valid only
when these buttons are enabled.
Note :
● If you are configuring the settings or performing an audio
playback test in the [Camera Record Setting] or [Event Audio
Setting] of the main menu, do so after you have closed this
dialog box.
● If the performance meter lights up in yellow or red, the
microphone sound may be interrupted. To make sure that audio
sound is successfully transmitted, perform operations such as
temporarily stopping the recording operation so that the
performance meter does not light up in yellow or red.
[Performance Meter] ( A Page 27)