JVC VR-N1600U - Manual (Page 31)

23
Selecting a language
The [Language Setting] screen appears when you start up this unit
for the first time. Select the language to use using the steps below.
1
Select a language
● Use the [2/D] or [10/0/E](8/E) button to select a language.
`
2
Use the [SKIP] button to select [OK], followed by
pressing the [16/ENTER](ZOOM IN/ENTER)
button
`
● The AThe system is being set up.B message may appear
depending on the setting, and the system is automatically
rebooted.
Memo :
● Selecting [OK] changes the color of the [OK] characters from
brown to orange.
Automatic Registration of Cameras
After you have started up this unit for the first time and finished
selecting a language, the [Auto Detect] screen appears.
1
Check to ensure that [Auto Detect] is selected,
followed by pressing the [16/ENTER](ZOOM IN/
ENTER) button
`
● The APlease wait...B message appears.
Memo :
● The characters of the selected item switches to orange color.
Memo :
● In the case of VR-N900U, the analog input appears on the [Auto
Detect] screen from the start as the
AAnalog-inB network
encoder (IP video server) of
A192.168.201.12B.
2
Check to ensure that the camera is detected
● After the message disappears, a list of detected cameras
is displayed.
● If all the cameras are not detected, press the [Auto Detect]
button again. If doing so does not solve the problem,
check the connection with the cameras and the IP
address of the cameras.
3
Replace the detected camera accordingly in
sequence
Use the [SKIP] button to select the Sort button, followed by pressing
the [16/ENTER](ZOOM IN/ENTER) button to sort the order of the
detected cameras in sequence.
`
● The Sort button allows you to perform [IP] sort, [MAC]
sort, [CH] sort, [MAKER] sort, or [MODEL] sort.
● After using the [SKIP] button to select the list, followed by
using [2/ D] or [10/0/E](8/E) to select a camera, use the
[SKIP] button to select [Up] or [Down], and press the [16/
ENTER](ZOOM IN/ENTER) button to change the
sequence of the cameras.
`
● Deselect the check box of any camera that you are not
using.
Note :
● Do not remove the check for Analog-In. (VR-N900U)
Memo :
● Priority is given to cameras at the top of the list during use, and
camera numbers will be registered in sequence from the top.
4
Use the [SKIP] button to select [Entry], followed
by pressing the [16/ENTER](ZOOM IN/ENTER)
button
`
● The camera that is automatically detected is registered in
the system.
5
Select the analog input channel and signal
format to be used (VR-N900U)
5
NR-N900U