JVC VR-N1600U - Manual (Page 108)

100
Applications
Specifying Generic Events
What is a generic event?
This is a function that uses TCP or UDP protocol communication as
an input event for this unit.
When character strings in the communication data received by the
unit matches the predetermined conditions, the corresponding
generic event is triggered. To define a generic event, you need to
configure the incoming data settings at this unit as well as the
outgoing data settings at the camera (or network device to be
used).
The procedures for configuring the incoming data settings at this
unit are described below.
1
Click the [Generic Events...] button on the
[Camera Recording Administator] screen
2
Select Generic and click [Add new event...]
A General Event settings
Memo :
● This unit receives generic events from the port that is specified
in [Alert Port] on the [Advanced] screen. ( A Page 98)
Camera Input/Output Port
and Events (continued)
Item Description
Add new event... For adding new events.
Edit selected... For editing the event selected in the [Defined
events] list.
Remove selected For deleting the event selected in the
[Defined events] list.
[Camera Recording Administator] Screen
[Generic
Events...] Button
A
B C
[Generic Events] Screen
Item Description
Event Name For specifying a name for the event. Enter a
unique name for the event.
Memo :
● The following characters cannot be used
as part of the event name.
< > & ^8217 ^8220 \ / : * ? | [ ]
Event Protocol For selecting the protocol that this unit uses
to receive data when detecting the event:
Any Receives and analyzes data that uses either
the TCP or UDP protocol.
TCP Receives and analyzes only data that uses
the TCP protocol.
UDP Receives and analyzes only data that uses
the UDP protocol.
Event rule type For specifying the rules when analyzing the
received data.
Match In order for an event to be triggered, the
received data must totally coincide with the
message specified in the [Event message
include] field of the [Event rules string]
section C, and must not contain any other
messages.
Search In order for an event to be triggered, the
received data must contain the message
specified in the [Event message include] field
of the [Event rules string] section C. Other
messages may be included in the data.
Event priority The same data may be used by different
events. Assigns the order of priority to each
event for determining the event to trigger
when the received data matches the criteria
of multiple events. Set the priority level to a
value between
A0B (lowest priority) and
A1000B (highest priority).
B
C
A
[Add New Event] Screen