JVC VR-N1600U - Manual (Page 37)

29
You can switch the resolution of the VGA output using the following
procedures.
● Press and hold the [FUNCTION] button, and press the [14/
ZOOM OUT](ZOOM OUT/CANCEL) button at the same time.
`
BPressing the button each time increases the resolution
value.
● Press and hold the [FUNCTION] button, and press the [15/
ZOOM IN](ZOOM IN/ENTER) button at the same time.
`
BPressing the button each time decreases the resolution
value.
Memo :
● Selecting a resolution not supported by the monitor may prevent
normal monitor synchronization.
Note that any incorrect changes made to the settings of this unit
may cause it to malfunction.
● Before making any changes, save the current settings to [Flash
Memory Utility] ( A Page 111) to allow you to restore the
previous settings should anything go wrong.
● It is recommended that you save the setting data before making
any changes.
● The section at the bottom left of NVR Viewer might not be
operative depending on the monitor resolution. In such a case,
double-click the bar of the currently opened upper section to
close it to enable the operation of the lower section.
Changing Monitor
Resolution
Preset
Values : 1024 x 768 (Default value)
1280 x 768
1280 x 1024
1600 x 1200
OPERATE
REC CONTROL
LIVE/BROWSE
SELECT
PTZ/PRESET
SERIAL
㧝 㧞 㧟 㧠
㧡 㧢*1/' 㧣
㧥  
㧤

   
CANCEL ZOOM OUT ZOOM IN ENTER
WARNING
ALARM
HDD
LOCK
SEARCH FUNCTION ALARM CLEAR KEY REC/STOP STOP(PB) PLAY
SKIP
REV FWD
VR-N900U
VR-N1600U/E
[15/ZOOM IN] Button
[FUNCTION] Button [14/ZOOM OUT]
Button
[ZOOM IN/ENTER] Button
[FUNCTION] Button
[ZOOM OUT/
CANCEL] Button
Precautions when
Changing Settings