Sanyo CHX03652 - Manual (Page 55)

3-11
1
2
3
4
5
6
7
8
Control of Mini ECO-i SYSTEM
CN1
(optional) (optional)
1 2 1 2
Indoor
unit
(sub) (main)
Receiver unit
Remote controller
terminal board
Ground
Wireless remote
controller kit
Wired remote
controller
Remote control wiring (field supply)
When 1 indoor unit is operated with 2 remote controllers:
(The indoor unit runs according to which of the remote controllers is assigned as the main or sub unit.)
* *
* Use field wiring cables with a
cross-sectional area of at least
0.5mm
2 to 2mm 2 .
* The maximum total length of
crossover cables must be no
longer than 400m.
CN1
(optional)
1 2 1 2
(optional)
Indoor
unit No.1
Indoor
unit No.2
Indoor
unit No.3
Indoor
unit No.4
Receiver
unit
(Main) (Sub)
Remote controller
terminal board
When several groups of indoor units are operated with 2 remote controllers:
(The remote controller (main or sub unit) can operate with any indoor unit.)
Wireless remote
controller kit
Wired remote
controller
Remote control
wiring among the
control groups
(field supply)
* Use field wiring cables with a
cross-sectional area of at least
0.5mm
2 to 2mm 2 .
* The maximum total length of
crossover cables must be no
longer than 200m.
* *
Ground Ground Ground Ground
Fig. 3-6
Fig. 3-5
Receiver PCB
Receiver unit
cover
ON 1 2 3 4
Adjustable
corner cap
S003
Bit 1: OFF ON
2. Wireless Remote Controller
(1) To assign the wired remote controller as the sub unit,
locate the address connector at the rear of the wired
remote controller PCB and disconnect it. Reconnect it to
the sub unit position.
(2) To assign the wireless remote controller as the sub unit,
locate the dip switch [S003] on the wireless receiver unit
PCB. Set the No. 3 switch to the ON position.
2-5. How to use the Test Run Setting
1. Set DIP switch [S003] No. 1 on the wireless receiver unit
PCB from OFF to ON.
2. All indicator lamps in the display section blink during test
run operation.
3. No temperature control is available during the test run.
4. After the test run, be sure to reset DIP switch No. 1 back
to the OFF position and check that no indicator lamps
are blinking. Then remount and attach the PCB cover as
before.
To avoid placing excessive operating load on the equipment,
use this function only when conducting the test run.
NOTE
AWG#20 to AWG#14
longer than 1320 ft.
AWG#20 to AWG#14
longer than 660 ft.