System controller – Sanyo CHX03652 User Manual
Page 98
3-54
Control of Mini ECO-i SYSTEM
1
2
3
4
5
6
7
8
4. System Controller
(c)
Automatic zone registration using the system
controller (SHA-KC64UG)
(1)
Press the
and
ZON E
buttons at the same
time for more than 4 seconds.
and CODE No. C1 will flash.
(2)
Select CODE. No. C2 by pressing
and
( ) button and press the
button.
C2 changes from flashing to ON state and
automatic zone registration will start.
(3)
Registered GROUP No. will be disappeared all.
(4)
Central address will be assigned from small
indoor unit address to large one in numerical
order automatically.
Finishing automatic zone registration,
changes from flashing to OFF.
(5)
If the error is happened, the “CHECK” starts
flashing and zone registration finishes at this
time. Press the
button.
(6)
Finally, complete automatic zone registration
mode by pressing the
button.
flashes for a few minutes, then OFF.
2053_M_I
ZONE
ZONE
1
ZONE
SELECT
GROUP
9
2
3
4
6
Fig. 3-34