Sharp AR-651 - Manual (Page 138)

1
2
3
4
5
6
7
8
9
10
11
12
7-4
WHEN THE GRAPHIC SYMBOLS FLASH ON THE TOUCH PANEL
MAX
Slide rail
A
B
1 Pull the tandem LCF out carefully until it comes to a
stop.
- Be careful not to touch the drawer slide rail.
2 Open some packages of paper, take out entire reams
of paper and set them aligned in tray
A
and tray
B
.
- When setting the paper, set the paper for
A
to the right
side, and set it for B to the left side. (The paper can be set
neatly if you pile it up gradually and alternately in trays A
and B .) Be sure that the center lever is not open ( refer to
the labels attached in the tandem LCF ).
- Up to 2500 sheets of paper (20 lb.Bond) can be set.
- Paper starts being fed from the elevator tray A at first, and
when it runs out of paper, the paper on tray B moves to the
position A .
- Set the paper so that it does not protrude beyond the line of
indication shown on the rear guide plate.
- Do not use creased, folded, wrinkled or damp sheets of
paper.
- Be careful not to touch the drawer slide rail.
3 Close the cover of the tandem LCF.
- Close the drawer completely. The elevator tray automatically
moves up to the paper feeding position.
2. ADD PAPER SYMBOL (Cont.)
Be careful not to let your fingers be caught when closing
the drawer.
Adding Paper to the Tandem LCF (Large Capacity Feeder)