Sharp AR-651 - Manual (Page 30)

1
2
3
4
5
6
7
8
9
10
11
12
2-6
HOW TO MAKE COPIES
Slide rail
2. SETTING COPY PAPER (Cont.)
Changing the Paper Size of the Drawer/Setting the Drawer for Special Uses
The paper size of the drawers of the copier can be changed to desired size. The drawers can also be set
for cover sheet, insertion, tab paper, thick paper and special sheets.
4 While pushing the size selection lever in the direction of
the arrow, set the side guide to the desired paper width
(indicated on the bottom surface of the drawer).
- Adjust the side guides with both hands.
3 Push the arrow part (right side) of the size selection
lever to unlock it.
5 Push the arrow part (left side) to lock the size selection
lever.
6 Place paper in the drawer(s).
- Place the paper in face down.
- Notes for placing paper in the drawer. Page 7-3, step 2
7 Push the drawer straight into the copier until it comes
to a stop.
- Be sure to push the drawer carefully and fully in.
Be careful not to let your fingers be caught when closing
the drawer.
Changing the Paper Size of the Drawer
1 Pull out the drawer toward you.
-Do not touch the slide rail of the drawer.
2 Push the lower part of the width guide in the direction of
the arrow to remove it, and reinstall the width guide
at the desired paper size (indicated on the bottom
surface of the drawer).