Sharp AR-651 - Manual (Page 36)

1
2
3
4
5
6
7
8
9
10
11
12
2-12
HOW TO MAKE COPIES
When the number of originals is too large to be set at one time,
you can divide the originals into two to ten sets and set them
one after another. To do so, place the first set of originals first,
and press the CONTINUE key while the scanning is in progress.
After they have been scanned, place the previous set of
originals.
When Using the Reversing Automatic Document Feeder (Cont.)
In the Single-feed Mode Page 5-3
2 Insert the original face up and straight along the
slides; it will then be pulled in automatically.
- When the original starts being pulled in, let go of it.
Slide
Slide
In the Continuous Feed Mode Page 5-2
1 After aligning the edges of originals well, place them
face up and align the slides to the width of the originals.
- Align the originals in the order from the top because they
will be fed from the top.
- One original sheet is also acceptable.
- Maximum number of sheets (all sizes) can be set in the
reversing automatic document feeder: 100 sheets (20lb.
Bond) or less than 0.62" in height.
- Be sure to set only originals with the same size. Mixed-sized originals Page 5-4
1 Align the slides to the desired original size.
3. SETTING ORIGINALS (Cont.)