Sharp AR-651 - Manual (Page 157)

1
2
3
4
5
6
7
8
9
10
11
12
7-23
3 Pull out the grip of the saddle staple holder toward
you and turn it 90 o clockwise in the direction of the
arrow.
4 Remove the empty staple case and set a new one.
- Replace both staple cases with new ones.
- Do not remove the seal holding the staples before the staple
case is set in the cartridge.
If test stapling fails to be performed and the following mes-
sage remains displayed, repeat the above procedure from
steps 1 to 7.
Set staple cartridge
6 Make sure that the finisher is attached to the copier
firmly and that LD, LT-R size paper is set in the copier.
- If one of the above paper sizes is not set, test stapling cannot
be performed.
7 Close the lower cover of the finisher. Test stapling
is then automatically performed on a blank sheet.
- This operation is carried out to avoid blank stitching.
5 Return the saddle stitch holder and the saddle stitch
unit to their respective original positions.