Sierra Raven EDGE - Manual (Page 110)

Configuration Commands
Rev 3.0B Feb.08 106
Figure 1-14: AceManager : EDGE/HSDPA
*NETAPN=apn
Easy entry of the APN. If left blank, the modem will attempt to
use the default subscriber value as defined by the account.
• apn=access point name
+CGQMIN
Minimum Acceptable Quality of Service Profile. Change
should be at carrierʹs request. Normally not required to be
changed.
+CGQREQ
Set Quality of Service Profile. Change should be at carrierʹs
request. Normally not required to be changed.
+COPS=mode,[format][,oper]
Manually specify an operator. Refer also to *NETOP.
• mode=0 : Automatic ‐ any affiliated carrier [default].
• mode=1 : Manual ‐ use only the operator <oper> specified.
• mode=4 : Manual/Automatic ‐ if manual selection fails,
goes to automatic mode.
• format=0 : Alphanumeric (ʺnameʺ) (G3x10 must use this
format).
• format=2 : Numeric
• oper=”name”