Sierra Raven EDGE - Manual (Page 95)

Raven EDGE
91 20070914
Figure 1-6: AceManager : PPP/Ethernet
*DHCPSERVER=n
• Act as a DHCP server for any Ethernet device connecting
to the Raven. DHCP (Dynamic Host Configuration
Protocol) allows one device, the DHCP server, to provide
dynamic IP addresses to any other device which requests
them.
• n=1 : Enabled. The modem will act as the primary DHCP
server for the network.
• n=2 : Enabled if no other DHCP server is detected
(default). If another DHCP server is detected on the
network, the Raven will not send out replies to DHCP
requests.n=0 : Disabled. The Raven X will not send out
replies to DHCP requests.
Tip: For PPPoE, set *DHCPSERVER=0.
*HOSTAUTH=n
Host Authentication Mode: Use PAP or CHAP to request the
user login and password during PPP or CHAP negotiation on
the host connection. The username and password set in
*HOSTUID and *HOSTPW will be used.
• n=0 : Disable PAP or CHAP request (Default).
• n=1 : PAP and CHAP.
• n=2 : CHAP
Tip: For PPPoE, set *HOSTAUTH=1 or *HOSTAUTH=2.