Sierra Raven EDGE User Manual

Page 91

Advertising
background image

Raven EDGE

87

20070914

*NETUID=uid

The login that is used to login to the cellular network, when 
required. 

uid=user id (up to 64 bytes) 

*STATICIP=d.d.d.d

Set the static IP required to be received from the network. If the 
modem does not get this IP address from the network, it will 
reset the internal hardware and try again. The default is 0.0.0.0, 
which allows any IP address from the network. 

d.d.d.d=IP address

Example: 

AT*STATICIP=192.168.1.23

Caution: STATICIP does not set the IP address of the modem, it
merely tells the modem which IP address to expect. If the expected IP
address is not granted while registering on the cellular network, the
modem will try to register on the network again until it receives that IP
address. If your account is set up for a dynamic IP address and you
set an address for *STATICIP, you may not be able to register on the
network at all since there is no guarantee you will receive the same
dynamic IP address again.

*STATUSCHK=n

Checks if an SMS message has been received by the modem.

n=1‐255 : Seconds between checks. 

n=0 : Never check.

*MODEMHISPEED

Set the internal serial link speed to the internal (radio) module.

n=0 : 115200 (default) 

n=1 : 230400

DNS

This group includes commands specific to the modem being 
able to use domain names instead of IP addresses for other 
configuration options. 

Advertising