Configuring modbus/bsap, Modbus overview, Telemetry remote terminal unit (rtu) – Sierra Raven EDGE User Manual

Page 63

Advertising
background image

Rev 3.0B Feb.08

59

8

8: Configuring Modbus/BSAP

Configuring the Raven

at the Polling Host
for Modbus on UDP

Configuring the

Remote Ravens for
Modbus with UDP

The Raven supports Modbus ASCII, Modbus RTU, BSAP, and 
can also emulate other protocols like DF1 or others using its 
Modbus Variable feature.

Modbus Overview

The Modbus Protocol, developed by Modicon in 1979, 
provides for client‐server (also referred to as master‐slave) 
communications between intelligent devices. As a de facto 
standard, it is the most widely used network protocol in the 
industrial manufacturing environment to transfer discrete/
analog I/O and register data between control devices. Modbus, 
BSAP, and other Modbus variations are often used in 
conjunction with telemetry devices.

Tip: This section is just a brief overview of Modbus. For more infor-
mation, refer to your Modbus equipment distributor or manufacturer or
http://www.modbus.org.

Telemetry

Telemetry is an automated communications process by which 
data is collected from instruments located at remote or inacces‐
sible points and transmitted to receiving equipment for 
measurement, monitoring, display, and recording. Trans‐
mission of the information may be over physical pairs of wires, 
telecommunication circuits, radios or satellite.

Remote Terminal Unit (RTU)

Modbus was originally designed to be used in a radio 
environment where packets are broadcast from a central 
station (also called master or host) to a group of remote units. 
Each remote unit, Remote Terminal Unit (RTU), has a 
hexidecimal identification number (ID). The first part of the 
broadcast packet contains an RTU ID which corresponds to the 
ID of one of the remote units. The Modbus host looks for the 
ID and sends to only the unit with the matching ID. The RTU 
would then reply back to the central station.

Advertising