Sierra Raven EDGE - Manual (Page 70)

Raven EDGE
66 20070914
a. Enable S82, UDP auto answer.
b. Set S83 to the idle time‐out applicable to your appli‐
cation, commonly 20.
4. Configure other RTU settings.
Other parameters may need to be changed, but this is
dependent on the RTU type being used. As a minimum, this
typically involves setting the proper serial settings to match
your RTU.
5. Optional: Dynamic IP Address
If you do not have a static IP, the host modem should be
configured to report its current IP to a Dynamic DNS (DDNS)
server with IP Manager.
You will need to match the name of the modem to the names
specified in the host modem’s MLIST or MLISTX for the
connected RTU.
When you configure IP Manager for the host modem, make
note of your modem name and domain setting in AceManager
in the menu selection Dynamic IP to be used with the remote
modems.
Figure 8-8: AceManager: Dynamic IP
When you use names instead of IP addresses, to ensure your
modems are updated quickly with the correct IP addresses for
the names, you will want to set the DNS settings as well. In
AceManager, select DNS.