Sony HDW-1800 - Manual (Page 12)

12
2-1 Control Panels
Chap
te
r 2
Lo
c
a
ti
on and
F
u
n
c
tion
o
f P
a
rt
s
To close the lower control panel
Push up the folding levers on both sides at the same time.
When closing the lower control panel, be careful not to
catch your fingers in the panel.
2-1-1 Upper Control Panel
a POWER switch
Pressing the “
j ” side of the switch powers the unit on.
When the unit is powered on, the LCD (see page 14)
lights.
b REMOTE buttons and RS-232C indicator
Press the 1 (9P) button or 2 (50P) button to select the
device controlling this unit.
1(9P): This unit is controlled by a device connected to the
REMOTE 1-IN(9P) or REMOTE 1-OUT(9P)
connector. The button lights when pressed.
2(50P): This unit is controlled by a device connected to the
REMOTE 2 PARALLEL I/O(50P) connector. The
button lights when pressed.
RS-232C indicator: This indicator lights when this unit is
communicating with a device connected to the RS-
232C connector.
c EJECT button
To eject the cassette, press this button. While the cassette
is being ejected, this button lights.
Ejecting with the EJECT button is a local operation. It is
not possible to eject a cassette in another VTR by remote
control.
d PHONES jack and control
Connect stereo headphones with an impedance of 8
Ω, to
monitor the sound during recording, playback and editing.
The control knob adjusts the volume.
It is possible to set an internal board switch so that the
output volume from the MONITOR OUTPUT L and R
connectors is controlled simultaneously.
For details, refer to the Installation Manual.
Lower control panel unlock button Note
Z
2 REMOTE buttons and RS-232C indicator
1 POWER switch
3 EJECT button
Cassette compartment
4 PHONES jack and control
Note