Sony HDW-1800 - Manual (Page 96)

96
9-4 Items in the Extended Setup Menu
Ch
apt
er 9 Set
up Men
u
s
808 INTERNAL AUDIO
SIGNAL GENERATOR Select the operation of the internal audio test signal generator.
OFF: No operation
SILNC: Silent signal
1KHZ: At 1 kHz, –20 dB FS sine wave is supplied to all audio input channels.
To output the internal audio test signal, display function menu page P08: AUD INP,
hold down the ALT/DELETE button, then select F6 (AUDIO SG).
To cancel the signal output, hold down the ALT/DELETE button and select F6
(AUDIO SG).
Note
When the system frequency is 24PsF or 23.98PsF, the frequency of the internal
audio test signal is reduced 4% of the normal frequency.
810 AUDIO EDIT PREVIEW
SWITCHER Set the output phase for the audio playback signal when any of F2 (INS TC), F3
(INS CUE), and F5 (ASSEMBLE) to F10 (INS A4) in function menu page P07:
E.PRESET is lit.
INT: The audio playback signal output phase is the same as the output phase in the
E-E mode. Select this setting when editing with a single VTR, or when
previewing while monitoring the VTR output signal.
EXT: The audio playback signal output phase is the same as the phase of an input
video signal or external reference video signal.
823 NON-AUDIO FLAG PB
(HDW-D1800 only) Controls the non-audio flag when the playback format is Digital Betacam.
Sub-item
1 CH1/CH2 During playback (except E-E mode), set the digital audio non-audio flag as follows.
OFF: OFF (the data is audio)
ON: ON (the data is non-audio)
AUTO: As follows
• Tape data has been read and confirmed: “ON” or “OFF”, according to the data.
• Tape data has not been confirmed: Current state is maintained.
Note
In the HDCAM format, the non-audio flag follows the setting of maintenance menu
item M372 during recording and E-E mode.
For more information about the maintenance menu item M372, refer to the
Maintenance Manual.
2 CH3/CH4
824 ANALOG LINE OUTPUT
SELECT Select the analog audio signals (tracks 1 to 8) to be assigned to audio output
channels 1 and 2.
tr1/2: Tracks 1 and 2 assigned to audio output channels 1 and 2.
tr3/4: Tracks 3 and 4 assigned to audio output channels 1 and 2.
tr5/6: Tracks 5 and 6 assigned to audio output channels 1 and 2 (HDW-D1800
only).
tr7/8: Tracks 7 and 8 assigned to audio output channels 1 and 2 (HDW-D1800
only).
825 AUDIO ADVANCE MODE Set the audio output phase.
OFF: Same as the video output phase
ON: One frame ahead of the video output phase
Menu items in the range 800 to 899, relating to audio control (Continued)
Item number Item name Settings