Sony HDW-1800 - Manual (Page 46)

46
5-1 Automatic Editing
Chapt
er 5 Edit
in
g
1
In function menu page P06: EDIT, select F6 (R/P
SEL) to select the VTR on which you want to check
the edit point.
2
According to the edit point you want to check, keep F9
(IN), F10 (OUT), F7 (AUD IN) or F8 (AUD OUT)
selected in function menu page P06: EDIT.
While the function item is selected, the time data of the
corresponding edit point is displayed in the upper line
of the ancillary message display.
To display the duration of an edit segment
You can display the duration between two edit points in the
following three cases, in the ancillary message display (see
page 17).
• When two edit points are set: the duration of the segment
between the two points
• When only one edit point is set: the duration of the
segment between the set edit point and the current tape
position
• When no edit point is set: the duration of the previous
edit segment
The duration is displayed in the ancillary message display,
for example: “DUR 0:01:10:00”.
Use the following procedure.
1
In function menu page P06: EDIT, select F6 (R/P
SEL) to select the VTR you want to check the edit
point.
2
In function menu page P06: EDIT, keep both F9 (IN)
and F10 (OUT) or both F7 (AUD IN) and F8 (AUD
OUT) selected.
While the function items are selected, the duration is
displayed in the ancillary message display.
5-1-5 Modifying and Deleting Edit
Points
If the edit points are not set correctly, for example if an
OUT point is before a corresponding IN point, and it is not
possible to carry out a preview or editing operation. In this
case, modify the erroneous edit point, or delete and enter it
correctly.
To modify an edit point
Use the following procedure.
1
In function menu page P06: EDIT, select F6 (R/P
SEL) to select the VTR you want to modify the edit
point.
2
According to the edit point you want to modify, select
F9 (IN), F10 (OUT), F7 (AUD IN) or F8 (AUD OUT)
in function menu page P06: EDIT, and turn the
MULTI CONTROL knob.
While the function item is selected, the time data of the
corresponding edit point is displayed in the ancillary
message display. Turn the MULTI CONTROL knob
clockwise to increase the value by one frame or
counterclockwise to decrease the value by one frame.
To delete an edit point
Use the following procedure.
1
In function menu page P06: EDIT, select F6 (R/P
SEL) to select the VTR you want to delete the edit
point.
2
Holding down the ALT/DELETE button, select F9
(IN), F10 (OUT), F7 (AUD IN) or F8 (AUD OUT) in
function menu page P06: EDIT according to the edit
point you want to delete.
The edit point is deleted according to the selection.
1,2
1,2