Sony HDW-1800 - Manual (Page 24)

24
2-2 Connector Panel
Chap
te
r 2
Lo
c
a
ti
on and
F
u
n
c
tion
o
f P
a
rt
s
b HDSDI (HD Serial Digital Interface) OUTPUT
connectors (BNC type)
Output HD format video/audio signals.
When the setting of F5 (CHARA) in function menu page
P04: MISC-1 is “ON”, connector 3 (SUPER) outputs a
signal with superimposed timecode, menu settings, alarm
messages and other text information.
c SDI (Serial Digital Interface) OUTPUT connectors
(BNC type)
Output D1 format video/audio signals.
When the setting of F5 (CHARA) in function menu page
P04: MISC-1 is “ON”, connector 3 (SUPER) outputs a
signal with superimposed timecode, menu settings, alarm
messages and other text information.
5 Power supply section
a AC IN (AC power input) connector
Use the supplied power cord to connect this to an AC
outlet.
b Ground terminal
Connect this to ground.
6 External device connectors
a REMOTE 2 PARALLEL I/O(50P) connector (D-
sub 50-pin)
Connect remote control signals from an external device.
For details, refer to the Installation Manual.
b VIDEO CONTROL(9P) (digital video processor
control) connector (D-sub 9-pin)
For remote control of the internal digital video processor,
connect the optional HKDV-900 Video Remote
Controller.
Always power off this unit before connecting the video
remote controller.
c REMOTE 1-IN(9P) (remote control signal input)
connector (D-sub 9-pin)
When using this unit together with another HDCAM VTR,
and a BVE-series BVE-700/900/910/2000/9000/9000P/
9100/9100P or other editor, connect the optional 9-pin
remote control cable from the other unit to this connector.
Depending on the setting in setup menu item 211, you can
use this connector alone, or in a loop-through
configuration with the REMOTE 1-OUT(9P) connector.
d REMOTE 1-OUT(9P) (remote control signal
output) connector (D-sub 9-pin)
This provides the loop-through output for remote control
signals from the REMOTE 1-IN(9P) connector.
Depending on the setting in setup menu item 211, you can
use this connector alone, or in a loop-through
configuration with the REMOTE 1-IN(9P) connector.
2 Ground terminal
1 AC IN connector
REMOTE 1-IN(9P)
REMOTE 2 PARALLEL I/O(50P)
REMOTE 1-OUT(9P)
RS232C VIDEO CONTROL (9P)
1 REMOTE 2 PARALLEL
I/O(50P) connector
2 VIDEO CONTROL(9P)
connector
3 REMOTE 1-IN(9P)
connector
4 REMOTE 1-OUT(9P)
connector
5 RS232C connector