Sony HDW-1800 - Manual (Page 51)

51
5-2 DMC Editing
Chap
te
r 5
E
d
it
in
g
1
In function menu page P06: EDIT, select F6 (R/P
SEL) to select the recorder (RECDER).
2
In function menu page P07: E.PRESET, select F5
(ASSEMBLE) or one INSERT button of F2 (INS TC),
F3 (INS CUE), and F6 (INS VID) to F10 (INS A4).
3
In function menu page P06: EDIT, select F4 (DMC).
This unit switches to the DMC edit mode, and F4
(DMC) lights.
4
Holding down the SHIFT/ENTRY button, select F9
(IN) or F10 (OUT) to set an edit point.
5
Select F6 (R/P SEL) to select the player (PLAYER),
and set the player edit IN point using the same
procedure as step 4.
It is not possible to set the player OUT point.
6
With F4 (DMC) selected, rotate the search dial to set
the initial speed.
To select normal playback speed as the initial
speed
Press the PLAY button.
The speed you set appears in the tape information.
7
When the initial speed setting is complete, release the
F4 (DMC).
8
Holding down the SHIFT/ENTRY button, select F2
(PREVIEW).
The tape is prerolled and then the recorder starts
operating at normal speed and the player starts at the
set initial speed.
9
On reaching the IN point, and F4 (DMC) begins to
flash, rotate the search dial to change the playback
speed.
While F4 (DMC) is flashing, the speed variations are
stored in memory. On reaching the OUT point, the F4
(DMC) changes from flashing to continuously lit
(pink), and the variable speed storing ends.
If the F4 (DMC) lights continuously before the
OUT point
This indicates that the memory has become full at that
point. Therefore, even before the OUT point is reached, it
is not possible to store speed variation data in memory any
more.
The maximum memory capacity is 120 seconds.
To exit the DMC edit mode
Holding down the ALT/DELETE button, select F4 (EDIT)
in function menu page P07: E.PRESET.
To carry out the DMC editing
Holding down the SHIFT/ENTRY button, select F1
(AUTOEDIT) in function menu page P06: EDIT.
DMC editing is carried out at the stored varying speed.
The stored playback speed settings are deleted from the
unit’s memory.
To check the editing results
Holding down the SHIFT/ENTRY button, select F3
(REVIEW).
Note